Left Seal, Replacing: Removing
- The transmission is installed.
-- Remove the left drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Grease the drill bit -3- so that the shavings stick to it.
Risk of Damaging the Bearing When Drilling
- Only drill through the metal ring of the shaft seal.
- Do not install the screw too deep.
-- Seal the opening on the transmission for the drive axle with a clean cloth -2-.
-- Carefully drill a 2 to 4 mm hole into the outer metal ring -1- of the seal.
-- Place the : SMN372500 under the transmission.
-- Install a bolt (approximately 4 mm diameter) into the drilled out hole on the seal.
-- Remove the seal with the : T10055 and the : T10055/2 .
-- Carefully remove the cloth. Make sure that no shavings get into the transmission when doing so.
-- Carefully clean the transmission and the opening for the drive axle.