Right Flange Shaft Needle Bearing, Replacing

Special tools and workshop equipment required 

• Press Plate: VW401 
• Press Plate: VW402 
• Press Piece - Rod: VW407 
• Press Piece - Multiple Use: VW412 
• Bearing Installer - Rear Wheel Bearing Kit: VAS3253 
• Bearing Installer - Needle Bearing: T10047 

Procedure 

-- Remove the right flange shaft. Refer to the appropriate Service Information .

-- Mount the : T10047  as illustrated.

• The markings "B" on both parts face each other
• The depressions -arrows- must be under the bearing.

-- Bolt the parts together all the way.

-- Remove the circlip -A-.

-- The shaft must be rotated when pressing off -arrow- so that the needle bearing contact surface on the shaft does not get damaged.

-- The shaft must be rotated when pressing on -arrow- so that the needle bearing contact surface on the shaft does not get damaged.

-- Secure the needle bearing with a new circlip.

-- Install the right flange shaft. Refer to the appropriate Service Information .