Overview - Transverse Link
- Eccentric Bolt
- Perform a vehicle alignment after loosening. Refer to VEHICLE ALIGNMENT .
- Do not turn more than 90° right or left (that is smallest to largest possible adjustment)
- Subframe
- Eccentric Washer
- Inner bore with tab
- Nut
- 95 Nm without Insert Tool - 18mm:T10179
- 80 Nm with Insert Tool - 18mm:T10179
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Eccentric Bolt
- Perform a vehicle alignment after loosening. Refer to VEHICLE ALIGNMENT .
- Do not turn more than 90° right or left (that is smallest to largest possible adjustment)
- Eccentric Washer
- Inner bore with tab
- Nut
- 95 Nm
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Upper Transverse Link
- The transverse link for a FWD vehicle is illustrated
- Removing and installing. Refer to UPPER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Nut
- Replace after removing
- Washer
- Washer
- For AWD vehicles only
- Bolt
- 130 Nm +180°
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Wheel Bearing Housing
- There are different versions. Refer to the Parts Information for allocation.
- Expanding Rivet
- Quantity: 2
- Nut
- Replace after removing
- Bolt
- 70 Nm +180°
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Lower Transverse Link
- The transverse link for a FWD vehicle is illustrated
- Removing and installing. Refer to LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Pop Rivet Nuts
- Stone Chip Protection
- There are different versions. Refer to the Parts Information for allocation.
- Bolts
- 8 Nm