Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Installing

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

• Replace the seals and O-ring after removal.

-- Coat the new O-rings -4- with coolant.

-- Make sure that both centering pins are installed in the cylinder block if necessary insert.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the Engine Temperature Control Actuator -N493- -3- into the connection piece and onto the centering pins in the cylinder block.

-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Install the Throttle Valve Control Module -GX3-. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING .

Additional procedures depending on the model. Refer to the appropriate service information

-- Perform the adaptation after replacing using the Vehicle Diagnostic Tester.