Coolant Pump Toothed Belt, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
Depending on the model, preliminary work may be required. Refer to the appropriate service information .
-- Remove the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .
- Pay attention to the direction or rotation: the bolts for the drive wheel have left-hand threads - there is a risk of damaging the threads.
-- Remove the bolt on the drive wheel -1- for the coolant pump and loosen three turns -arrow-. Use :VAG1410 and :T10360 .
-- Remove the toothed belt -2-.