TT / TTS / TT RS - Technician Reference Document
WARNING: This page is about a different car, the 2020 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Vehicle Preparation
| □ | → Set adaptation channel to enable CD Ripping using Guided Functions (if equipped with not available) Set adaptation channel (via Special functions > Service work > 5F-Activating / deactivating storage of music). Also referred to as CD Ripping. Perform 3 button reset of the MMI to complete the activation. Refer to the owners manual for model-specific button sequence |
| □ | → Perform any open campaigns Follow instructions listed in campaign documentation |
| □ | → Perform diagnostic work Connect Vehicle Diagnostic Tester - Select "Diagnosis" mode and start diagnosis - Perform vehicle identification - Deselect "Working with Guided Fault Finding - Switch to "Special functions" tab and select following program: ■ Delivery Inspection Total ■ - Start program by selecting "Carry out check" - Continue to follow instructions on screen and complete the process - Switch to the "Control units" tab, press the "Guided Fault Finding" button and launch Guided Fault Finding as far as the test plan - The static event memory entries must be evaluated and, if necessary, processed using Guided Fault Finding - Exit diagnosis; diagnostic log for delivery inspection is sent automatically |
Exterior
| □ | → Check all key buttons and features Check functionality of all keys. Verify vehicle starts and runs with all keys and the start / stop button. Verify all doors and trunk remotely lock / unlock with all keys, including all door handle sensors with Advanced Key (if equipped) |
Lighting and Windshield
| □ | → Test front washers. Correct aim if necessary Headlights must be on to test functionality of the headlight washers |
Trunk Inspection
| □ | → Install wheel bolt cover removal tool from PDI kit into trunk tool kit Install wheel bolt cover removal tool from PDI kit and wheel lock key (if applicable) into trunk tool kit |
| □ | → Set spare tire pressure (not available for TT RS) See separate "Audi Normal Load Condition Tire Pressure Table" posted on ServiceNet under Pre-Delivery Inspection |
| □ | → Check battery clamps for proper torque Refer to Elsa Pro for specification |
Interior
| □ | → Check operation of window, lock, and seat controls Check operation of all switches: Locks, windows, seat adjustment, heated seats (if equipped) and child safety features |
| □ | → Inspect mirrors for proper operation Inspect folding, adjustments, right side tilt in reverse, heating |
| □ | → Check rear view mirror operation Check self-dimming function / lighting (if equipped) |
| □ | → Verify proper operation of climate control Ensure proper heating and A / C cooling and open all panel vents for all zones |
| □ | → Inspect operation of all power outlets Inspect operation of front outlet, aux. outlet under armrest, and rear outlets |
Settings
| □ | → Set Time source setting to "GPS" and set Auto daylight savings time to "on." Change time zone appropriate to the dealer location |
| □ | → Verify and set language and measurement units This can be changed in the Settings menu by going to Menu > Vehicle > Vehicle settings |
| □ | → Verify Speech Dialog System is operating Press the "Talk" button and verify several commands |
| □ | → Set "Entertain. Fad." in Parking aid to an audible level Via "Menu > Vehicle > Left Option > Driver Assistance > Parking Aid" |
| □ | → Set dealership location in navigation (if equipped) Set dealership location for following back to dealership during road test |
| □ | → Turn off Manual Speed Warning (if equipped) This can be changed in the Driver Assistance settings by going to Menu > Vehicle > Driver Assistance > Speed Warning > Manual->Select Off |
Media / Radio / SAT
| □ | → Verify HD RadioTM is turned "off" This can be found in the Radio / Settings Menu |
On-Hoist Inspection
| □ | → Inspect wheel bolts for proper torque Use torque wrench to verify |
| □ | → Install wheel bolt covers and center caps as supplied Wheel bolt covers and center caps can be found in the PDI kit |
| □ | → Set and store tire pressures for either sold vehicle OR stock inventory vehicle If a known "sold" unit, set to appropriate Normal Load Condition. See separate "Audi Normal Load Condition Tire Pressure Table" posted on ServiceNet. If going to stock, set to maximum recommended tire pressures listed on the B-pillar door jamb, and store tire pressure values in Car / System menu |
Driving Performance
| □ | → Verify engine performance and acceleration Listen for abnormal noise / vibrations |
| □ | → Test drive vehicle applying brakes several times Apply brakes at least 4 times at 20 m.p.h. (35 km / h) to clean brake rotors. Check for abnormal noise / vibration / pulsation |
Driver Assistance
| □ | → Verify operation of Audi parking system plus (if equipped) Verify operation of Audi parking system sensors with rear view camera (if equipped) |
Roadster Functionality (if equipped)
| □ | → Test operation of power folding top Perform with engine running to conserve battery power |
Post-Road Test Inspection
| □ | → Check engine oil level Fill oil to the max level when the vehicle is at operating temperature |