Transmission Mount, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
-- Fasten the transmission mount -A- on the longitudinal member.
-- When re-installing the transmission mount -1-, align it according to the markings made earlier and fasten it in place -arrows-.
CAUTION:
Risk of damaging threads in transmission support by inserting bolts at an angle.
- The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts -arrows-. If equipped, lift the rear of the transmission using a floor jack or the :VAS6931 .
- Remove the :10-222A only when the bolt for the subframe mount -arrows- have been tightened to the tightening specification.
-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.
-- Remove the :10-222A from the engine.
-- Install the Engine Control Module -J623-. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .