Flywheel, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Dual-Mass Flywheel & Bolts

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of destroying the flywheel.

Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.
When removing the bolts, make sure that the bolt head does not come in contact with the flywheel.
Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.

-- Place the :3067 into the hole on the cylinder block -B-.

Fig 2: Identifying Flywheel Retainer

Courtesy of AUDI OF AMERICA, LLC

-- Loosen and remove the bolts for the flywheel and remove the flywheel and sensor wheel.