LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2021 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Crankshaft, Cylinder Block (Servicing - 5-Cylinder 2.5L TFSI Engine (Ea 855 EVO)) [Coupe]) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Installing

Ribbed Belt, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

-- Pivot the tensioner counter-clockwise.

-- Mount the ribbed belt on the ribbed belt pulley. Refer to Figure.

-- Release the tension on the tensioner.

-- Check the ribbed belt for correct positioning.

-- Start the engine and check the ribbed belt routing.

Additional procedures depending on the model. Refer to RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals