Sensor Wheel, Checking
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Gauge - Sender Wheel:T10473
CAUTION:
There is a risk of destroying the sensor wheel by magnetic force.
- Do not place the sensor wheel near magnets (for example lamp base, speakers).
- If the drive plate/flywheel or the sensor wheel disjoints itself or was replaced, the sensor wheel function must be checked before installing. Refer to SENSOR WHEEL, CHECKING .
Procedure
- Sensor wheel removed. Refer to FLYWHEEL, REMOVING AND INSTALLING .
-- Check the entire circumference of the sensor wheel with the :T10473 as shown.
Sensor wheel test diagram
A -
Sensor Wheel OK
B -
Sensor Wheel Faulty