Vibration Damper, Removing And Installing: Removing

Depending on the model, preliminary work may be required. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Remove the Starter generator ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the cover.

Courtesy of AUDI

-- Remove the bolt -arrow- and the idler roller.

-- Place the Adapter :T40330/5  with Counterholder :T40330/1  on the vibration damper and secure using the M8x35 bolt -arrow- ; from the Counterholder Counter holder: T40330  (23 Nm), by placing the Spacer Sleeve :T40330/3  underneath.

Courtesy of AUDI

-- Remove the bolt -1-.

-- Remove the bolt -arrow- and remove the counterholder and vibration damper.