Input Shaft Seal, Replacing, Clutch Housing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Crankshaft/Power Steering Seal: T20143
- Thrust Piece: T40300
Procedure
- Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
-- With the : T20143 carefully remove the seal -arrow- from the housing.
-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.
- Pay attention to the installation position.
-- Drive the new seal in all the way using the : T40300 .
-- Dual Clutch, Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .