Parking Lock Solenoid N486/Drive Position Sensor G676, Removing and Installing: Installing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Push the Drive Position Sensor -G676- onto the parking lock shaft; while doing so, pay attention to the different notches -arrows- and hand-tighten the bolt -1-.
- Check if the splines on the Drive Position Sensor -G676- are flush with the splines on the parking lock shaft.
- Tighten the bolt -arrow- to the tightening specification.
NOTE:
When installing the Parking Lock Solenoid -N486-, pay attention that the alignment pin is seated correctly
- Install both bolts -arrows- with lightened spring force and tighten to the tightening specification.
- To do this using a pin punch shaft turn the parking lock approximately 3° against the spring force.
NOTE:
Pay attention to the correct installation position!
- The lever from the parking lock is flush to the shaft splines -arrow-
- If necessary align with less spring force!
NOTE:
- If necessary the spring pin can also be pushed in using pliers.
- Never drive in the tensioning pin because the shaft will be damaged.
- Press the tensioning pin -1- in using the Removal Tool -T40437- -A- and -T40437/1- -B-.