Parking Lock Shaft Seal, Replacing: Procedure
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear noise insulation. Refer to the appropriate Service Information.
- Remove the bolts -arrows- and push the coolant pipe for the transmission to the side. (different versions)
NOTE:
Ignore -items 1 and 2-.
- Remove the bolts -arrows- and move the parking lock emer- gency release cable -1- to the side. (different versions)
- Press the tensioning pin -1- out using the Removal Tool -T40437- -A-.
- Depending on the transmission, the parking lock lever may be installed in various positions. See the illustrations above and below.
- Remove the bolt -2-.
- Disconnect the connector -3-.
- Remove the bolts -arrows- and the parking lock cover -1-.
- Remove the seal with the Thrust Piece -T10040/3-.
- Press in the new seal with the Thrust Piece -T10040/3- to the installation dimension 0.5 mm.