Overview - Flywheel And Dual Clutch

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Flywheel and Dual Clutch Seals And Bearings

Courtesy of AUDI OF AMERICA, LLC

Flywheel
- Refer to the Parts Information because there are different versions depending on the date of manufacture.
- Removing an installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH COVER .
- For the input shaft
Dual Clutch
- Refer to the Parts Information because there are different versions depending on the date of manufacture.
- Removing an installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Engaging Bearing
- Pay attention to the installation position
- Can only be replaced together with the dual clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Slave Cylinder
- Can only be replaced together with the dual clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Bolt
- Tightening specification 12 Nm + 90°
- Tighten diagonally to the tightening specification
- Replace after removing
Seal
- Replace after removing
Double Shaft Seal
- Replace after removing
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .
Guide Sleeve
- Pay attention to the installation position
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .
Seal
- Replace after removing
Seal
- Replace after removing
Seal
- Replace after removing
Alignment Sleeve
Bolt
- Tightening specification 5 Nm + 30°
- Tighten evenly
- Not present depending on the version
Bolt
- Tightening specification 60 Nm
- M10 X 15.5