Parking Lock Solenoid N486/Drive Position Sensor G676, Removing and Installing: Removing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear noise insulation. Refer to the appropriate Service Information.
- Remove the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Remove the bolt -arrow- and the oil pipe -1-.
- Remove the bolts -arrows- and push the coolant pipe for the transmission to the side (different versions)
- Depending on the version, remove to ensure access to the coolant pipe.
- Remove the bolts -arrows- and move the parking lock emer- gency release cable -1- to the side. (different versions)
- Press the tensioning pin -1- out using the Removal Tool -T40437- -A-.
- Depending on the transmission, the parking lock lever may be installed in various positions. See the illustrations above and below.
- Remove the bolt -2-.
- Disconnect the connector -3-.
- Remove the bolts -arrows- and the parking lock cover -1-.
- Remove the bolts -arrows-.
- At the same time using a pin punch shaft turn the parking lock approximately 3° against the spring force in direction of -arrow-.
- Remove the Parking Lock Solenoid -N486-.
- Remove the bolt -arrow- and the Drive Position Sensor - G676-.