Solenoid Valves And Pressure Regulating Valves In Valve Body, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Cover: T40322/1-4
Support: T40321
Ruler (2 pc.): T40100

Tip:

Check before the repair, if the necessary replacement parts are available. Refer to the Parts Information.

CAUTION:

The system is under pressure.

Deactivate the ATF pump and drain the hydraulic pressure reservoir before removal.

-- Using the Vehicle Diagnostic Tester in the Transmission Control Module -J217- empty the ATF pressure reservoir and disable the Transmission Fluid Auxiliary Hydraulic Pump -V552-. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .

CAUTION:

Contamination damages the Mechatronic.

Pay attention to absolute cleanliness when working on hydraulic control.
Even a small amount of debris can lead to system malfunctions.
Remove the replacement parts from their packaging just prior to installing them.
Protect open oil channels from debris.

Electric allocation of the pressure regulating valves and solenoid valves. Refer to TRANSMISSION CONTROL .