Overview - Bumper Cover, S Line From Product Improvement

Fig 1: Exploded View Of Bumper Cover (S Line From Product Improvement)

Courtesy of AUDI OF AMERICA, LLC

1. Trim Molding
   • Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, S LINE FROM PRODUCT IMPROVEMENT .
2. Bumper Cover Lower Section
   • There are different versions. Refer to the Parts Information.
   • Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
3. Cap
   • Left: for the tail lamp bolt
   • Right: for the tail lamp bolt and towing eye
4. Cover Strip
   • Removing and Installing. Refer to COVER STRIP, REMOVING AND INSTALLING .
5. Bumper Cover Lower Section
   • Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
   • Bumper Cover, Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
6. Mount
   • for lane change assistance control module
   • Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
7. Bolt
   • Quantity: 3
   • Tightening specification. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
8. Bumper Cover Upper Section
   • Removing and Installing. Refer to BUMPER COVER UPPER SECTION, REMOVING AND INSTALLING .
   • Bumper Cover, Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
9. Bolt
   • Quantity: 3
   • 2 Nm
10. Bolt
    • 2 Nm
11. Mount
    • Side
    • For the bumper cover
    • Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, SIDE .
12. Bolt
    • Quantity: 4
    • Tightening sequence. Refer to Figure.
13. Mount
    • Lower
    • For the bumper cover
    • Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, BOTTOM .
14. Nut
    • Quantity: 3
    • 4 Nm
15. Nut
    • Quantity: 4
    • 4 Nm
16. Bolt
    • Quantity: 2
    • 1.5 Nm
17. Bolt
    • Quantity: 4
    • 2 Nm
18. Trim Molding
    • For exhaust system trim
    • Removing and Installing. Refer to TRIM MOLDING FOR EXHAUST SYSTEM TRIM, REMOVING AND INSTALLING, S LINE FROM PRODUCT IMPROVEMENT .
19. Exhaust System Trim
    • Removing and Installing. Refer to EXHAUST SYSTEM TRIM, REMOVING AND INSTALLING, S LINE FROM PRODUCT IMPROVEMENT .