Shaft for the Parking Lock, Removing

• Drive Position Sensor -G676- removed. Refer to SHIFT MECHANISM or to the appropriate service information. .

-- Disengage and release the tension of the spring -2- in the direction of -arrow- from the shaft for the parking lock -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the rest linkage -3- on the shaft for the parking lock -1-.

-- Drive out the shaft for the parking lock -1- and sleeve -2- in the direction of -arrow A- out of the clutch housing.

Courtesy of AUDI OF AMERICA, LLC

-- The pivot out the shaft for the parking lock -1- in the direction of -arrow B- from the clutch housing.

Install the Shaft for the Parking Lock 1

Fig 1: Install the Shaft for the Parking Lock -1-

Courtesy of AUDI OF AMERICA, LLC

-- Guide the shaft from the parking lock -1- with the spring -2- in the hole in the clutch housing -arrow A-.

-- Then push back the shaft -1- in the mount in the clutch housing -arrow B- and engage in the rest linkage -3-.

-- Drive in the sleeve -1- using the Extracting Tool - Thrust Piece: T40413/15  -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the seal -1- using the Extracting Tool - Guide Sleeve: T40413/14  -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Engage the spring -2- in the shaft for the parking lock -1-.

Courtesy of AUDI OF AMERICA, LLC

Tightening Specifications 

• Refer to OVERVIEW - PARKING LOCK