LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2021 >> SQ5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Gears, Shafts (7-Speed Dual Clutch Transmission 0CJ, 0CL, 0CK, 0DK, 0DN, 0DP, 0HL)) >> 35 Gears, Shafts >> Output Shaft >> Overview - Output Shaft >> Overview - Output Shaft, Vehicles Without Self-Locking Center Differential

Overview - Output Shaft, Vehicles Without Self-Locking Center Differential

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Output Shaft, Vehicles Without Self-Locking Center Differential Exploded View
GWWA35-10454Courtesy of AUDI OF AMERICA, LLC
  1. Internal Multi-Point Bolt
    • 300 Nm
    • Replace after removing
  2. Inner Race
    • Bearing "H"
    • For output shaft roller bearing
    • Removing. Refer to Figure.
    • Installing. Refer to Figure.
  3. Drive Wheel for Spur Gear
  4. Spacer Sleeve
  5. 4th Gear
  6. 6th Gear
  7. Thrust Washer
    • For 2nd gear assembly
  8. 2nd Gear Assembly
  9. Needle Bearing
    • For 2nd gear assembly
  10. Inner Race/Needle Bearing
    • For 2nd gear assembly
    • Removing. Refer to Figure.
    • Installing. Refer to Figure.
  11. Synchronization
    • For the 2nd gear assembly / reverse gear assembly
    • Installation position: the bevel of the locking collar -arrow- points to the 2nd gear assembly
    • Overview. Refer to Overview - Synchronization .
    • Installation position. Refer to Figure.
    • Pressing out the synchronizer hub. Refer to Figure.
    • Installing the synchronizer hub. Refer to Figure.
  12. Reverse Gear Wheel
  13. Needle Bearing
    • For reverse gear wheel
  14. Inner Race/Needle Bearing
    • For reverse gear wheel
    • Removing. Refer to Figure.
    • Installing. Refer to Figure.
  15. Thrust Washer
    • For reverse gear wheel
  16. Bearing Bracket
  17. Thrust Washer
    • For 1st Gear Assembly
  18. 1st Gear Assembly
  19. Needle Bearing
    • For 1st Gear Assembly
  20. Inner Race/Needle Bearing
    • For 1st Gear Assembly
    • Removing. Refer to Figure.
    • Installing. Refer to Figure.
  21. Synchronization
    • For 1st Gear Assembly / 3rd Gear Assembly
    • Overview. Refer to Overview - Synchronization .
    • Installation position. Refer to Figure.
    • Pressing out the synchronizer hub. Refer to Figure.
    • Installing the synchronizer hub. Refer to Figure.
  22. 3rd Gear Assembly
  23. Needle Bearing
    • For 3rd gear assembly
  24. Output Shaft
  25. Bearing Inner Race
    • Bearing "F"
    • For output shaft roller sleeve
    • Only for AWD vehicles
    • Removing. Refer to AWD Vehicles .
    • Installing. Refer to AWD Vehicles .
  26. Circlip
    • Only for AWD vehicles
scientia non olet · About LEMON Manuals