Input Shaft 1, Removing And Installing Separately: Removing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Gear set removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .

AWD Vehicles

Courtesy of AUDI OF AMERICA, LLC

For vehicles with AWD, the bearing inner race must be disassembled before the gear set is removed.

-- Remove the circlip -arrow-.

-- Remove the bearing inner race -arrow- using the Two-Arm Puller: VAS251001 and Seal Installer - Shaft Seal: T10431/1 .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and remove the shift forks for 4/6 gear and 5/7 gear together.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the input shaft 1 from the gear set.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Damage to input shaft 1

When removing the input shaft 1, the 7th gear wheel may already be loosened and can fall.