Input Shaft 1, Removing And Installing Separately: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Carefully guide the input shaft 1 into the gear set in direction of -arrow-. While doing so, make sure the needle bearings -A and B- are installed correctly.
-- Position the shift forks and secure with the bolt -arrow-.
AWD Vehicles
-- Warm the bearing inner race using the : VAS6414 to approximately 100 °C (212 °F) and push in all the way with the shoulder -arrow A-.
-- Install the circlip -arrow-.
-- Install the gear set. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .