Overview - Gear Set, Vehicles With Self-Locking Center Differential
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Oil Pipe
- Bolt
- 3 Nm +90°
- Replace after removing
- M6 X 30
- Gear Positioner with:
- Transmission Input Speed Sensor 1 -G632-
- Transmission Input Speed Sensor 2 -G612-
- Gear Position Distance Sensor 1 -G487-
- Gear Position Distance Sensor 2 -G488-
- Gear Position Distance Sensor 3 -G489-
- Gear Position Distance Sensor 4 -G490-
- Tightening specification and sequence. Refer to Fig 2.
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Oil Pan
- Replace after removing
- Bolts
- 3 Nm +90°
- Replace after removing
- M6 X 30
- Needle Bearing
- Bearing "31"
- Seal
- Replace after removing
- Hydraulic Pressure Reservoir
- Draining. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Disposing. Refer to HYDRAULIC PRESSURE RESERVOIR, DISPOSING .
- Tightening specification and sequence. Refer to Fig 2.
- Bolts
- Tightening specification and sequence. Refer to Fig 2.
- Replace after removing
- Bearing Bracket with Roller Bearing
- Bearing "N"
- Tightening specification and sequence. Refer to Fig 2.
- Gear Set
- Removing and Installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Disassembling and Assembling. Refer to GEAR SET, DISASSEMBLING AND ASSEMBLING .
- Needle Bearing
- Bearing "33"
- Bolts
- 6 Nm +30°
- Gearshift rail gear positioner module
- M6 X 50
Gear Actuator, Pressure Reservoir, Gear Carrier - Tightening Specification and Sequence
-- Tighten the bolts in four steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 9- | 3 Nm |
| 2 | -1 to 6- | 90° (M6 X 30) |
| 3 | -7 to 9- | 5 Nm |
| 4 | -7 to 9- | 120° (M6 X 40) |