Bearing Bracket, Disassembling And Assembling: Notes

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate: VW402
Press Piece - Rod: VW411
Press Piece - 28x100mm: VW421
Press Piece - Bushing - 50mm Diameter: VW432
Puller - Transmission Gears - Thrust Piece: T10309/5
Wiring Harness Repair Set - Hot Air Blower: VAS1978/14A
Gearbox Assembly Tool: T40213A
Two-Arm Puller: VAS251001
Extracting Tool: T40413

Disassembling

Press Out the Shaft for the Reverse Gear Intermediate Sprocket 1

Fig 1: Press Out the Shaft for the Reverse Gear Intermediate Sprocket -1-

Courtesy of AUDI OF AMERICA, LLC

2 -

Press Piece - Rod: VW411

3 -

Gearbox Assembly Tool - Adapter: T40213/9

4 -

Press Plate: VW402

Remove the locking ring -item 1- OVERVIEW - BEARING BRACKET => List Item: Circlip beforehand.

-- Remove the reverse gear intermediate sprocket, needle bearing and thrust washers from the bearing bracket.

Drive Out the Input Shaft Ball Bearing 1

Fig 2: Drive Out the Input Shaft Ball Bearing -1-

Courtesy of AUDI OF AMERICA, LLC

2 -

Press Piece - Bushing - 50mm Diameter: VW432

Reverse gear intermediate sprocket is removed. Refer to Fig 1.
Remove the bolts -item 6- OVERVIEW - BEARING BRACKET => List Item: Bolts beforehand and remove the retaining plate for the bearing -item 7- OVERVIEW - BEARING BRACKET => List Item: Retaining Plate.
Tension the bearing bracket in a vise.

Drive Out the Output Shaft Ball Bearing 1

Fig 3: Drive Out the Output Shaft Ball Bearing -1-

Courtesy of AUDI OF AMERICA, LLC

2 -

Press Piece - Bushing - 50mm Diameter: VW432

Remove the locking ring -item 16- OVERVIEW - BEARING BRACKET => List Item: Circlip beforehand.
Tension the bearing bracket in a vise.