Pinion, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Warm the transmission housing with the : VAG1416 in the area of the bearing seat -arrow- approximately 100 °C (212 °F).
-- Insert the shim "S 3 " -1- in the transmission housing.
-- Then insert the pinion -3- quickly without tilting all the way in the transmission housing.
-- Determine the shim "S 4 " and place on the double angular contact ball bearing. Refer to PINION, ADJUSTING .
- Installation position of the circlip -1- : the bevel -arrow- points upward and the flat side points to the double angular contact ball bearing.
-- Install the circlip -1- in the transmission housing groove all around.