Overview - Drive Pinion
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Circlip
- Replace after removing
- For the pinion preload sleeve
- Preload Sleeve
- Replace after removing
- Equipment version: vehicles without final drive reinforcement
- Installation position: the high collar -arrow A- points upward to the circlip
- Sleeve
- Equipment version: vehicles with final drive reinforcement
- Circlip
- Insert in the groove all around the transmission housing
- Installation position: the bevel -arrow B- points upward and the flat side points to the double angular contact ball bearing.
- Shim "S 4
"
- Selecting thickness. Refer to PINION, ADJUSTING .
- Double Angular Contact Ball Bearing
- Replace after removing
- Installation position: the groove all around -arrow C- points upward to the preload sleeve
- Removing and Installing. Refer to PINION, REMOVING AND INSTALLING .
- Pinion
- Can be replaces separately. Refer to the Parts Information.
- Removing and Installing. Refer to PINION, REMOVING AND INSTALLING .
- Adjusting. Refer to PINION, ADJUSTING .
- Shim "S3
"
- Selecting thickness. Refer to PINION, ADJUSTING .
- Transmission Housing