Right Flange Shaft, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the circlip after removal.
-- Insert the circlip -1- with the Circlip Pliers: VAS5503A .
-- Check the right flange shaft seal for damage and replace if necessary.
-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.
-- Insert the right flange shaft.
-- Fill the transmission fluid and check the level. Refer to the appropriate service information. .
Tightening Specifications
- Refer to OVERVIEW - DRIVE AXLE .
- Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .