Control Module, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Tightening specifications. Refer to OVERVIEW - ALL WHEEL DRIVE CLUTCH .
-- Install the All-Wheel Drive Control Module -- as follows:
- Replace the O-rings -1- and -2- .
- Coat the o-ring with ATF.
- The flattened driver -3- must be guided into the groove on the actuator shaft -4- .
-- Tighten the bolts -arrows- .
-- Connect the connector -3- to the All-Wheel Drive Control Module -- -4- .
-- Secure the cable to the all-wheel drive clutch -arrow- .
-- If equipped, secure the heat shield -2- with the bolts -1- .
-- If equipped, install driveshaft heat shield -1- .
If the control module was replaced:
- If the AWD Control Module -J492- was replaced then additional work is now necessary. Refer to ADDITIONAL WORK FOR VEHICLES WITH "quattro ultra" .