All-Wheel Drive Clutch Torque, Checking

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

The torque is only checked when it suggested based on "Guided Fault Finding" .

Special tools and workshop equipment required

Socket - 36mm:T10125 (1/2 inch)

Fig 1: Socket - 36mm (1/2 inch) T10125
36 mm Socket, 3/4 inch, commercially available
or
3/4 inch adapter for 1/2 inch
Counter Holder:T40345

Fig 2: Counter Holder T40345
Torque Wrench 1332 40-200Nm:V.A.G 1332

Fig 3: Identifying Torque Wrench 1332
Torque Wrench 80-400Nm:V.A.G 1576

Fig 4: Identifying Torque Wrench V. A. G 1576
Vehicle Diagnostic Tester

Fig 5: Vehicle Diagnostic Tester VAS5051B

Only check the torque if "Guided Fault Finding" specifically requests it.

-- Remove the driveshaft. Refer to the appropriate Service Information .

-- Connect the Vehicle Diagnostic Tester and switch on the ignition.

-- On the Vehicle Diagnostic Tester, select the function 22 - Actuator test under Guided Functions in the 22 - AWD electronics folder.

-- Start the selected program and follow the instructions in the display of the Vehicle Diagnostic Tester.

-- Mount the tool as shown to check the torque of the all-wheel drive clutch.

A - Torque Wrench 1332 40-200Nm:V.A.G 1332 and Torque Wrench 80-400Nm:V.A.G 1576

Use the Torque Wrench 80-400Nm:V.A.G 1576 to check higher torques.
To do so, a 36 mm Socket3/4 inch (commercially available) or a 3/4 inch adapter for 1/2 inch is required.

-- Install the driveshaft. Refer to the appropriate Service Information. .