All-Wheel Drive Clutch Input Shaft Seal, Replacing: Installing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the running and sealing surface.

-- Coat outer edge of the seal with ATF.

-- Fill the space between the sealing/dust lip halfway with Sealing Grease:G 052 128 A1 .

Installed position: The open side of the seal faces the transmission housing.
Do not tilt the seal when installing it.

-- Install the seal using the Bearing Installer - Carrier Bearing:3350 to dimension -x- .

Dimension -x- = 11.2 mm underneath the housing lower edge

-- Install the all-wheel drive clutch. Refer to ALL-WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING

-- Add ATF for all-wheel drive clutch and reset the >>oil age adaptation values<< in the All-Wheel Drive Control Module -J492- . Refer to ALL WHEEL DRIVE CLUTCH, REMOVING AND INSTALLING .