Overview - Transmission, Vehicles With Self-Locking Center Differential
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Gear Set
- Removing and Installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Hydraulic Pressure Reservoir
- Draining. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Disposing. Refer to HYDRAULIC PRESSURE RESERVOIR, DISPOSING .
- Dual Clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
- Flywheel
- Removing and Installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Alignment Sleeve
- Seal
- Replace after removing
- Transmission Housing Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Replace after removing
- Transmission Fluid Pump
- Removing and installing. Refer to the appropriate service information.
- Bolt
- Tightening specification. Refer to the appropriate service information.
- Transmission Housing
- Removing and Installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Seal
- Replace after removing
- Oil Guide Piece Drive Axle
- Differential Housing Bolt
- Replace after removing
- Tightening Specification. Refer to -item 8- OVERVIEW - CENTER DIFFERENTIAL => List Item: Bolt .
- Circlip
- Replace after removing
- Alignment Sleeve
- Seal
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to Fig 3.
- Replace after removing
Transmission Housing - Tightening Specification and Sequence
-- Tighten the bolts in three steps in the sequence shown:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1 | -1 to 9- | Install by hand evenly until the bolt head contact the transmission housing. |
| 2 | -1 to 9- | Tighten one after the other to 10 Nm + 90° |
| 3 | -Arrow- | Tighten the remaining bolts clockwise to 10 Nm + 90° |
Gear Set - Tightening Specification and Sequence
-- Push the centering bracket -A- all the way in.
Bolt -6- without centering sleeve.
-- Tighten the bolts in two steps in the sequence shown:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1 | -1 to 6- | Install by hand evenly until the bolt head contact the transmission housing. |
| 2 | -1 to 6- | Tighten one after the other to 15 Nm + 90° |