Output Shaft Roller Bearing, Replacing, Vehicles without Self-Locking Center Differential
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the bolts -2-.
-- Remove the bearing shell -1-.
-- Break off the tab -arrow- of the oil guide shell using pliers.
- It is necessary to replace the oil guide shell!
Roller Sleeve for the Output Shaft 1, Extend, Vehicles without Self-Locking Center Differential
Fig 1: Roller Sleeve for the Output Shaft -1-, Extend, Vehicles without Self-Locking Center Differential
2 - Internal Puller: VAS251615
3 - Counter Support: VAS251623
4 - Bearing Installer - Wheel Bearing: 3144
Roller Sleeve for the Output Shaft 1, Driving In, Vehicles without Self-Locking Center Differential
Fig 2: Roller Sleeve for the Output Shaft -1-, Driving In, Vehicles without Self-Locking Center Differential
3 - Seal Installer - Gearbox: 3295
Installation position of the roller sleeve: the surrounding groove -arrow- points to the Seal Installer: 3295 .
- Beforehand, insert a new oil guide shell -2-.
-- Lay the bearing shell -1- onto the roller sleeve.
-- Tighten the bolts -2- to the tightening specification.