Front Parking Lock Emergency Release Cable, Removing and Installing, Q5: Removing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
There is a risk of an accident from the vehicle starting to roll.
- Pull the parking brake button to activate the electro-me- chanical parking brake.
- Remove the center console. Refer to the appropriate Service Information.
- Remove the noise insulation.
- Release the retainers in direction of -A arrows- and slide the sleeve -1- on the emergency release cable in the direction of -arrow B-.
- Disengage the rear emergency release cable from the front emergency release cable in direction of -arrow C-.
- Remove the nuts -3-.
- Release the catches in direction of -arrows- and lower the bracket -2- for the emergency release.
- Remove the rear noise insulation. Refer to the appropriate Service Information.
- Equipped on some models: remove the tunnel underbody trim panel. Refer to the appropriate Service Information.
- Loosen the heat shield for the tunnel and place on the drive- shaft. Refer to the appropriate Service Information.
- Remove the bolts -arrows- and free up and remove the park- ing lock emergency release cable -1-.