Transmission Fluid Pan, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Removed transmission, if transmission is installed: Refer to the appropriate service information. .
CAUTION:
The system is under pressure.
- Deactivate the ATF pump and drain the hydraulic pressure reservoir before removal.
- Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR
-- Drain the ATF. Refer to the appropriate service information. .
-- Remove the bolts -arrows-.
- The coolant hose -2- stays connected to the ATF cooler.
-- Remove the bolts -arrows- and remove the protective plate -1-.
-- Place the Used Oil Collection and Extraction Unit: SMN372500 underneath.
-- Only loosen the bolts -2- and remove the bolts -1 and 3-.
-- Remove the ATF pipe -1- and the ATF -2- cooler from the oil pan.
-- Seal the open lines and connections with clean plugs from the : VAS6122 .
-- Remove the bolts in the sequence -25 to 1- and remove the transmission fluid pan.