Transmission Fluid Auxiliary Hydraulic Pump -V552-, REMOVING AND INSTALLING: Installing: Notes
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Contamination damages the Mechatronic.
- A clean work environment is required for working on the Mechatronic.
-- Place the ATF pump on the ATF motor at the same time pay attention to the correct alignment of the anti-twist mechanism in direction of -arrows-.
-- Drive the ATF motor and ATF pump using the : T10492 in the valve body.
-- With the : T10492 install and tighten the bolts evenly all the way.
-- Remove the : T10492 .
-- Install the Transmission Control Module -J217-. Refer to Transmission Control Module -J217-, REMOVING AND INSTALLING .
- After replacing the Transmission Fluid Auxiliary Hydraulic Pump -V552- the function "calibrating the fluid auxiliary hydraulic pump" must be performed using the Vehicle Diagnostic Tester.