Solenoid Valves And Pressure Regulating Valves In Valve Body, Removing And Installing: Installing: Notes
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Coat the valve surface with ATF and push in the valves all the way.
-- Hold the Solenoid Valve 5 -N92- -arrow-.
-- Using the Precision Straight Edge (2 pc.): T40100 align the connection evenly as shown.
-- Connect the contact element evenly.
-- Install the bolts -arrows- and tighten to the tightening specification.
-- Tighten the bolts -arrows- to the tightening specification.
-- Install the Transmission Control Module -J217-. Refer to Transmission Control Module -J217-, REMOVING AND INSTALLING .
-- Install the mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- After replacing the Solenoid Valves -- the function "Calibrating valves" must be performed using the Vehicle Diagnostic Tester.