Overview - MECHATRONIC
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Fluid Pan
- Removing and Installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Replace after removing
- M6 X 30
- Seal
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to Fig 4.
- Replace after removing
- Bracket
- Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-
- Removing and Installing. Refer to Hydraulic Pressure Sensor 1 -G545- AND Hydraulic Pressure Sensor 2 -G546-, REMOVING AND INSTALLING .
- Seals
- Replace after removing
- Contact Element
- Bolt
- 3 Nm +90°
- Replace after removing
- M6 X 25
- O-Ring
- Replace after removing
- Bleed Pipe
- Dust Ring
- Seals
- Replace after removing
- Seal
- Replace after removing
- For vehicles with Parking Lock Solenoid -N486-
- Mechatronic
- Removing and Installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Mechatronic Bolts
- Tightening specification and sequence. Refer to Fig 3.
- M6 X 90
- Bolt
- 3 Nm +90°
- Replace after removing
- For vehicles with Parking Lock Solenoid -N486-
- M6 X 22
- Seal
- Replace after removing
- Refer to Fig 5
- Transmission Control Module -J217-
- Oil Pipe
- For vehicles with Parking Lock Solenoid -N486-
- Wiring Guide
- Replace after removing
- Seals
- Replace after removing
- ATF Pipe
- Replace after removing
- Seals
- Replace after removing
Transmission Fluid Pan - Tightening Specification and Sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 25- | Install all the way by hand |
| 2 | -1 to 25- | 3 Nm |
| 3 | -1 to 25- | 90° additional turn |
Mechatronic - Tightening Specification and Sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 7- | Install all the way by hand |
| 2 | -1 to 7- | 8 Nm |
| 3 | -1 to 7- | 120° additional turn |
Hydraulic Pressure Sensor 1G545 and Hydraulic Pressure Sensor 2G546 - Tightening Specification and Sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 7- | Install all the way by hand |
| 2 | -1 to 7- | 8 Nm |
| 3 | -1 to 7- | 120° additional turn |
Overview - Seal