ATF Cooler, Removing and Installing: Installing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
NOTE:
- Replace the ATF line with seals after removing.
- Clean the ATF cooler before installing.
CAUTION:
ATF cooler leak!
- Pay attention to the ATF pipe installation position.
- The side of the pipe with three seals faces the ATF cooler.
- Install the bolts all the way in by hand and tighten in the previously specified tightening sequence.
- If the bolts are difficult to reach, tighten them using the Torx Screwdriver Bit - T30 -VAS6959-.
- Bleed the cooling system if the drained coolant is less than or equal to 0.5 Liter, otherwise fill and bleed the cooling system. Refer to the appropriate service information.
- Check the ATF level. Refer to ATF Level, Checking .