Overview - Cylinder Block, Transmission Side
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
- For assembly work secure the engine on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
- Bolt
- Replace after removing
- 60 Nm +90°
- Drive Plate
- With the bearing flange
- Check the contact surfaces on the bearing flange and the torque converter holes for cracks and wear grooves.
- Removing and Installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and Installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Check using the Vehicle Diagnostic Tester Refer to SENSOR WHEEL, CHECKING .
- After removing and installing or replacing perform the listed adaptation in the 0001 - Engine Electronics Functions "0001 - Steps after replacing components" using the Vehicle Diagnostic Tester.
- Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Alignment Pin
- Crankshaft
- Overview. Refer to OVERVIEW - CRANKSHAFT .