Exhaust Temperature Regulation Components, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi Q5 and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Audi A4/A5/A6/A7/A8:
-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .
Audi Q5/Q7/Q8:
-- Remove the tower brace(s). Refer to TOWER BRACE, REMOVING AND INSTALLING .
Continuation for All except Audi Q7/Q8:
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -1- and free up the wires:
-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -item 2- and Exhaust Gas Temperature Sensor 4 -G648- -item 3- :
Audi Q7/Q8:
-- Disconnect the connector -2- and free up the wires.
-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -item 1- and Exhaust Gas Temperature Sensor 4 -G648- -item 3-.