Exhaust Temperature Regulation Components, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi Q5 and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.

-- Make sure there is enough clearance during installation.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- If removed, install the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .

-- If removed, install the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .