Left Engine Support, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Audi A4/A5:

Courtesy of AUDI

-- Lift the clamp -3-, remove and free up the coolant hose.

-- Disconnect the connector -1- for the Engine Coolant Level Sensor -G32-.

-- Remove the bolt -4-, and push the coolant expansion tank -2- to the side.

Audi Q5:

Courtesy of AUDI

-- Disconnect the connector -2- for the Charge Air Pressure Sensor -G31-.

-- Loosen the screw-type clamp -1- and remove the air duct pipe from the Throttle Valve Control Module -GX3- (example illustration).

-- Seal off any open lines and connections with plugs that are thoroughly cleaned from the Engine Bung Set:VAS6122 .

Continuation for All Vehicles:

Courtesy of AUDI

-- Remove the upper bolts -2- for the engine support -1-. (Shown with the engine removed.)

-- Remove the left support bearing. Refer to ENGINE SUPPORT BEARING, REMOVING AND INSTALLING .

-- Remove the left engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Remove the lower bolts -3- and the left engine support -1-. (Shown with the engine removed.)