Part II

Part I. Refer to Part I .

Part III. Refer to Part III .

Fig 1: Exploded View Of Turbocharger, 3.0L Engine

Courtesy of AUDI OF AMERICA, LLC

1. Nut
   • 30 Nm
   • After loosening, replace the stud bolt. Refer to -item-  4
2. Tensioning Bracket
3. Seal
   • Replace after removing.
4. Stud Bolt
   • 15 Nm
   • After loosening, replace the nut. Refer to -item-  15
5. Tensioning Bracket
6. Nut
   • 30 Nm
   • After loosening, replace the stud bolt. Refer to -item-  4
7. Oil Return Line
   • Replace after removing.
8. Clip
9. Air Duct Pipe
10. Bolt
    • Tightening specification. Refer to -item-  9
11. Seal
    • Replace after removing.
12. Air Duct Pipe
13. Bolt
    • Tightening specification. Refer to -item-  12
14. Seal
    • Replace after removing.
15. Nut
    • Step 1: 15 Nm
    • Step 2: 30 Nm
    • Step 3: After finishing the procedures, tighten the nuts to 30 Nm
    • Replace after removing.
16. Turbocharger
    • Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
17. Screw-Type Clamp
    • 20 Nm
    • Replace after removing.
18. Seal
    • Replace after removing.
19. Coupling
    • If a new turbocharger is installed, replace the coupling
20. Nut
    • Step 1: 15 Nm
    • Step 2: 30 Nm
    • Step 3: After finishing the procedures, tighten the nuts to 30 Nm
    • Replace after removing.
21. Seal
    • Replace after removing.
22. Stud Bolt
    • 15 Nm
    • After loosening, replace the nut item  20