Airbag Unit With Igniter, Removing And Installing: Installing
Install in reverse order of removal and note the following:
Pyrotechnical components can deploy unintentionally.
There is a risk of injury.
- Discharge static electricity by briefly touching the door striker.
- Make sure the connectors are pushed in all the way and that they engage audibly.
- Make sure the wires are not pinched.
-- Press in the connector to secure it in the pockets on the steering wheel.
-- Position the driver side airbag in the steering wheel and press on until it audibly engages.
-- If battery was disconnected, follow all steps required for reconnecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
Risk of airbag deployment.
There is a risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.