Indicated on display
| Rapid data transfer HELP Select function XX |
-- Press buttons 0 and 2 to select "Check DTC Memory" function 02.
Indicated on display
| Rapid data transfer Q 02 - Check DTC Memory |
-- Press Q button to confirm input.
The number of stored DTCs or "No DTC recognized" appears in the display.
| X DTC recognized |
-- Press → button.
Stored malfunctions are displayed and printed out one after the other Diagnostic Trouble Code (DTC) table, DTC TABLE .
-- After displaying and printing out last diagnostic trouble code, press → button.
If malfunctions were recognized, go to "End Output" function 06, switch ignition off, repair malfunctions, then check and erase DTC memory.
The DTC memory cannot be erased until after it has been checked.
If there is a malfunction that was not detected by the On Board Diagnostic (On Board Diagnostic) program, troubleshooting should be expanded to include the electrical test ELECTRICAL CHECK .