Knee Airbag With Igniter, Removing And Installing, Front Passenger Side: Installing

WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Pyrotechnical components can deploy unintentionally.

There is a risk of injury.

- Discharge static electricity by briefly touching the door striker.

Install in reverse order of removal and note the following:

-- Install the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

CAUTION:

There is a risk of damaging the surface of the knee airbag from mechanical stress.

- After completing a procedure, perform a visual inspection to make sure that the surface of the knee airbag is not damaged.

Make sure the wires are not pinched.
If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.