Overview - Driver Side Airbag
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Steering Wheel
- Overview. Refer to OVERVIEW - STEERING WHEEL .
- Steering Column Electronics Control Module -J527-
- Overview. Refer to OVERVIEW - STEERING COLUMN SWITCH MODULE .
- Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .
- Driver Side Airbag
- Use a T15 TORX® screwdriver to release, approximately 80 mm long
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .