Cover And Cushion, Removing And Installing, Rear Bench Seat: Installing
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Engage the rear molding into the seat frame first, and then pull the cover tight.
-- Flip the protective strip -1- over 180° toward the inside in direction of -arrow A-.
-- Engage the protective strip in the groove on the molded part in direction of -arrow B-.
- After installing, make sure the cover is free of folds.