Modular Wiring Routing, Disconnecting And Connecting
- Follow the safety precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Individual Wire, Removing
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Secure the front seat to the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Open the rear cable holder -1- for the wire routing on the seat pan using a flat-head screwdriver to release the hook -2-.
-- Remove the corrugated tube -3- from the cable holder.
-- Open the front cable holder -1- using a flat-head screwdriver to release the hook -3-.
-- Remove wiring bracket from the corrugated tube -2-.
-- Disconnect the halves of the corrugated tube.
-- Cut the cable tie if necessary to remove a single wire.
-- Replacing a faulty wire. Refer to WIRING HARNESSES, REPAIRING .
-- Cut through the cable tie and remove the individual wire.
Individual Wire, Installing
Install in reverse order of removal and note the following:
-- When bundling and placing individual wires, make sure the wires are not twisted.
- During installation, all cable ties, cable holders and clips must be installed at the same location.
- Slide the connectors on until they click into place.
-- Install the front seat. Refer to Installing .