Alloy Disc Wheel: Notes
Wheel and tire imbalance causes front end and steering wheel vibrations.
WARNING:
If these instructions are not complied with, damage to the center Torsen differential may result, which will not be covered by the warranty.
- Lift vehicle at both axles during balancing and place on sensor blocks (refer to operating instructions from the balancing equipment manufacturer).
- Disengage the parking brake.
NOTE:
Alloy wheels are available in different styles. The "aerostyle" wheel is shown.
- Tire
- To ensure driving safety, replace tires on front or rear axle in pairs, not individually
- The tires with the deeper tread depth should always be on the front wheels
- Use only tires from the same manufacturer, of the same type of construction and tread type
- Tire sizes WHEELS AND TIRES
- Alloy disc wheel
- 6J x 15, ET 45 mm
- 7J x 15, ET 45 mm
- 7-1/2 J x 15, ET 40 mm
- 8J x 16, ET 40 mm
- Valve
- Replace when replacing tire or wheel
- Wheel bolt
- 110 Nm (81 ft lb)
- -M14- x 1.5 x 27.5 mm
- Lock cylinder
- Install on wheel bolt and lock
- Cap
- Install on lock cylinder
- Holding spring for balance weights
- Balance weights
- Maximum 60 grams (2 oz.) per rim permissible
- Cover